- PEX Products
- Heating Supplies
- Plumbing Supplies
- HVAC - Air Conditioning
- Fittings & Valves
-
Shop By Brand
Field Controls
EWC Humidifiers
This category contains EWC humidifiers and humidifier accessories
M+MG2 Series Draft Controls
This is a series of compact, rugged, heavy-duty controls for use on large residential, commercial, and industrial applications. The Field Type M+MG2 Draft Control provides precise draft regulations for solid fuels, oil, gas, or oil/gas appliances requiring only the simplest, on-the-job adjustments depending on which fuel is to be utilized. These units are used in Solid, Oil, or Gas fuel systems. These units can be used in Commercial or Industrial applications. …
Draft Inducers
Field Draft Inducers solve the drafting problems caused by short chimneys, undersized vent pipes and negative building pressures.
Draft Inducers are designed for easy installation in a wide variety of applications, including oil or gas-fired furnaces, water heaters, and boilers. For venting single or multiple appliances, use a control kit.
DI Paks are available for 24 volt and millivolt applications and include all controls necessary. …
UV Parts and Accessories
Contains UV Air Treatment System Replacement Lamps, the Ultraviolet Surface Treatment System, SmartLamp Ultraviolet Air Treatment Systems, the TrueUV Coil Treatment System, and UV-Aire Purification Systems. …
Air Boosters
Field Air Boosters improve air flow and distribution of conditioned air to "problem" rooms in homes and businesses. They are mounted in ductwork and improve air flow by up to 1400 cfm, improving heating/cooling system efficiency and saving energy. There are nine models designed for round or square ducts up to 14" in diameter. …
MG-1 Series Draft Controls
A double-acting control for gas-fired furnaces and boilers is widely used for conversion burner installations, gas draft-induced appliance operation with mechanical draft inducers, or sidewall power venters. It is also recommended for use on gas atmospheric appliances where a draft hood cannot be installed, and can improve combustion stability and draft on many gas atmospheric installations with venting problems.
The MG-1 provides precise, accurate control of drafts at levels higher than permitted by a standard draft diverter, which is a frequent requirement with gas. Because it is double-acting, it opens out to relieve positive vent system pressures as low as .01". Draft adjustments using weights are simple and accurate from .01" to .1". These units are used in Gas Applications. …
M Series Draft Controls
The M Series control lends itself ideally to conditions requiring a great deal of stability and accuracy. Designed for settings from .01" to .1", the Field M Control is recommended for oil or coal-fired residential heating applications. The Type M features an infinitely variable screw adjustment, permitting an extremely fine instrument setting. The M employs side wings to control air direction with gate curvatures designed to compensate for differences in horizontal and vertical settings. These units are suitable for Oil or Coal Residential applications. …
RC Series Draft Controls
These units are used on Oil or Coal systems, and Residential and Commercial applications.
The RC Draft control is furnished as standard equipment on many leading brands of oil or coal-fired heating equipment. It is calibrated to allow for easy adjustment to the furnace or boiler manufacturer?s specifications. Designed for settings from .02" to .08", this control is so sensitive that instrumentation should be used when adjusting the unit during installation. …
Safety Switches
Thermal safety switches efficiently detect flue gas spillage due to a blocked flue, continuous down drafting or inadequate draft condition. With the safety switch wired in series with the burner circuit, the switch will de-energize the systems burner or burner control once it senses the spillage of hot flue gases. Available for gas-fired and oil-fired applications. …
Combustion Air Systems
This section contains Combustion Air Products. For the proper operation and venting of gas or oil heating appliances, sufficient outside air must be supplied to the structure to make up for the air lost from venting heating appliances, fireplaces, clothes dryers, exhaust fans and other building air losses. These products aid this process. …
Control Kits
Control Kits (CK) are required to control the operation of SWG/CV Power Venters. Control Kits can also control the operation of Field Draft Inducers. …
Field Controls Venting
This category contains a variety of Field Controls venting parts for use with boilers. …
Power Venters
This category contains Field Controls PV Series and SWG Power Venters.
Field Controls OVD Dampers
Field Controls, the venting solutions company, has developed a new Oil Vent Damper that significantly reduces off cycle heat loss in oil burning appliances, resulting in less fuel consumption, a 5% to 10% savings in energy costs, and an up to 2% gain in AFUE. Normally, when the thermostat is satisfied and the burner shuts down, the residual heat in the burner chamber escapes via the chimney. The Field Oil Vent Damper prevents this loss by effectively closing the vent during the off cycle. Field testing indicates the average homeowner can save 5% to 10% on fuel costs with a properly installed OVD. …
Field Controls Automatic GVD Dampers
The Field Vent Damper works automatically to allow natural draft during appliance operation while preventing residual appliance heat and conditioned air from escaping during off cycles. It also prevents the infiltration of cold air during down drafts. It’s made of stainless steel and is available in 8 sizes, 4" through 10" and 12". …
Water Softeners
This category contains Water Softeners. Water Softeners are appropriate for a smaller home, up to 1-1/2 baths. They treat water as it enters your home, minimizing the effects of hard water. Benefits include brighter clothing, cleaner dishes, less detergent consumption and less water usage. Helps protect the entire plumbing system. The system includes a state-of-the-art valve that allows monitoring and control of every function and cycle. This system also saves water by metering use and regenerating only when necessary. The multi-level salt shelf traps dirt (sediment) and debris away from the brine draw area, enabling the use of inexpensive types of water treatment salt reducing maintenance. Includes water bypass valve. …
More about Field ControlsField Controls is an industry leader in draft, venting, and combustion air technology. The company was founded by Ted Field in 1927 in Evanston, Illinois and moved to Kinston, North Carolina in 1977. Field Controls first specialized in large, custom-built draft controls and has expanded its product line to include venting, combustion and air purification products. The company remains the worldwide leader in draft controls for oil, gas and solid fuel applications.
Join Our Mailing List - Sign up and receive special offers and coupons
