Zoom

QFG Fan-Forced Register Wall Heater (1,500 Watts - 120 Volt)

SKU:QFG1512T2M

Brand: Qmark

QFG Fan-Forced Register Wall Heater (1,500 Watts - 120 Volt)
Qty	Price
	$174.95 / each

Usually Ships in 7-10 Days

Shipping Info

Easy Returns

Specs

Product Specs
BTU: ? BTU close BTU stands for British Thermal Units and is used to describe heat output. One BTU is enough heat to raise one pound of water by one degree.	938
	2560
	3838
	5118
Application:	Heating
Color:	Sienna White
Voltage: ? Voltage close Voltage, or volts, is a measurement of the difference between two electric fields (in heating terms, the difference between the Earth's electrical field and the electricity running through your wires).	120v
Wattage: ? Wattage close Wattage, or watts, is the amount of electrical power that an appliance uses or generates.	750
	1500
	1125
	275
Amperage: ? Amperage close Amperage, or amps, refers to the amount of electricity flowing through the wires.	9.4
	3.1
	6.3
	12.5
Height:	7-3/4"
Width:	16-7/8"
Depth (Inches):	5-1/8"
Type:	Wall Recess Kit

Description for Qmark QFG1512T2M

RESIDENTIAL: QFG Series electric in-wall heaters are suitable for use in almost any room. Use single heaters in smaller rooms such as bedrooms and bathrooms. Use multiple heaters (controlled by a single thermostat) in larger rooms such as living rooms and family rooms. Wattage should be determined through heat loss calculations.

COMMERCIAL: Suitable as the primary heat source in smaller rooms and as supplemental heat in almost any general use area.

Features:

Dual Protection: Thermal cutout with indicator light and one time thermal fuse
Tangential blower for whisper quiet operation
Sienna White baked enamel finish
Built-in thermostat
Open coil element assures quick heat and low maintenance
Three piece construction for ease of installation
Permanently lubricated, dust-protected bearings
Clip-n-Fit feature: allows the installer to change the wattage of the heater to a lower output without moving jumper wire. Each heater is factory wired for its maximum wattage. To change wattage, clip out either jumper 1 or 2 as shown in the installation manual for desired wattage. This Patented Clip-N-Fit® feature also prevents the operator to change wattage after installation to a higher wattage.